Contact form
Project
Flush trim after banding on a studio kitchen.
The flush trim stage followed edging on the Observatory studio kitchen run. The board set moved from banded panels to a clean edge finish, with the focus on chip control, trim height and a kerf note that matches workshop use in South Africa. First-board reference matters here because a small change in band thickness can show immediately on light cabinetry.
For this handoff, we kept the first board photo and noted what the operator saw at the edge before the rest of the batch went through. In Johannesburg conditions, glue squeeze-out, dust on the support face and a blunt trim edge can all mark the finish, so those checks were logged with the archive. If your panel build is similar, send the board details and city through our contact form.
What transfers from this job is the sequence, not just the image. Start with Trim Flush Blade matched to the panel build, then check Edgeband flush against the actual tape thickness, corner breakout and the final sight line under workshop lighting. That gives a usable reference when another kitchen line needs the same edge finish.
A project page shows what was recorded on one completed run. Machine speed, extraction load, adhesive build-up and the day’s moisture in the shop can all change the edge result, even when the panel spec looks close. Use the notes as a workshop reference, then verify settings on your own material before pushing the full stack.
Verified Google reviews
Our contact form lists the Kya Sands, Johannesburg details for workshop enquiries. Include the panel material, edging type and whether the issue is flush finish, chipping or trim wear so the right catalogue path can be checked first.
